Tremron Roofing Nationwide

Tremron Roofing: The Cupertino Owner’s Guide

Tremron concrete and clay roof tiles installed in Cupertino typically run $600-$2,500 to repair a localized section and $8,000-$20,000 for full replacement, depending on underlayment condition and deck accessibility. We stock replacement field tiles, ridge caps, and underlayment membrane compatible with Tremron’s Old Country, Slate, and Shake series, and we can usually match discontinued colors from our supplier archive. Most Cupertino homeowners discover a Tremron tile problem after a Santa Clara Valley wind event or when a winter rain reveals water staining on the ceiling below.

Call (669) 202-9618

Which Tremron Models This Applies To

Tremron’s roofing line splits into three series most common in Cupertino: Old Country (the rounded barrel tile), Slate (flat profile with chamfered edges), and Shake (textured, wood-look concrete). Each series carries a color code stamped on the back edge of the tile, usually a two-letter abbreviation like “TB” for Timberwood Brown or “ST” for Slate Gray. The critical compatibility gotcha is the nail flange height: Old Country tiles require a 1.75-inch exposure, while Slate and Shake use a 2.25-inch pattern. Mixing these on the same roof plane creates a stagger mismatch that channels water.

For OEM versus aftermarket, Tremron still manufactures most colors but discontinued their “Adobe Red” and “Coastal Sand” blends in 2019. We source remaining stock through our distributor in San Jose and, when that’s exhausted, match from Eagle Roofing or Westlake Royal’s equivalent profiles. The underlayment membrane is where we don’t substitute: Tremron’s 30-year warranty requires ASTM D226 Type II felt or an equivalent synthetic underlayment with a 90-day UV rating, and we document that spec on every quote.

Signs Your Tremron Roofing Is Failing

• Cracked or broken field tiles, especially after wind. Cupertino’s spring gusts off the Santa Cruz Mountains can lift tiles that were already stress-fractured from thermal cycling. The crack starts at the nail hole and propagates outward, invisible from the ground until the piece shifts.
• Water stains on ceiling drywall, often in a straight line. This pattern usually traces to a failed underlayment seam beneath intact tiles. Tremron tiles shed water; the membrane beneath catches what gets through. When the membrane degrades, water travels the deck slope and exits at the nearest penetration.
• Loose ridge caps or hip tiles that rattle in wind. Ridge caps are mortar-set or foam-adhered, and the bond fails when the substrate flexes. In Monta Vista and other Cupertino neighborhoods with 1970s framing, we’ve found ridge boards that sag enough to break the mortar bed.
• Efflorescence, the white powder on tile surfaces. This is mineral salt migration from the concrete body, accelerated by Cupertino’s dry summers followed by winter rain. It signals moisture is entering and exiting the tile repeatedly, which weakens it over time.
• Granule or color coating loss, leaving a mottled appearance. On Tremron’s concrete shake profile, the surface stain is a slurry coat, not through-body color. Once it wears, the gray concrete shows through. This is cosmetic but indicates the tile has reached roughly 75 percent of its useful life in our climate.

Before

After

Replacement Cost & What’s Included

Here’s how Tremron roofing work breaks down in Cupertino:

• Tile repair (localized, under 50 sq ft): $400-$1,800 - includes removal of damaged tiles, membrane patch, replacement tiles, and mortar reset
• Partial re-roof (one slope or section): $2,500-$6,500 - includes tear-off to deck, new underlayment, replacement tiles, and valley metal
• Full roof replacement: $8,000-$20,000 - includes complete tear-off, deck inspection and repair, ASTM D226 Type II underlayment or equivalent synthetic, all new Tremron or matched tiles, and permit

The range driver is deck condition. We don’t know how much plywood needs replacement until we remove the tiles, so our written quote includes a per-sheet price for OSB replacement - signed off before we cut, per Clause 1 of the Haven Standard. Every job includes a documented photo record of deck condition, membrane installation, and final tile layout. The 365-Day Done Right Promise covers labor and materials.

DIY or Call Us?

There’s a safe middle ground and a hard stop. A homeowner can walk the roof on a dry day - or better, inspect from a ladder with binoculars - to note cracked tiles, missing pieces, or displaced ridge caps. Mark the locations with chalk and photograph them. That’s useful information.

The hard stop is tile removal and replacement. Concrete tiles weigh 6-10 pounds each, and a full bundle stresses the roof structure if stacked improperly. More critically, walking on Tremron tiles without distributing weight across multiple tiles - using a foam pad or crawl board - causes point-load cracks that aren’t visible immediately but fail within a season. Underlayment work requires removing battens, which are pressure-set and easy to split. We recommend a trained crew for anything beyond visual inspection. Call (669) 202-9618 to schedule a free estimate; we’ll photograph what we find and quote the repair in writing before any work starts.

FAQs